New Development Area and
Comprehensive Development Area
6.5
(vi) (vii)
R2
5
(viii) (ix)
R3
3
(viii) (ix)
Notes:
General
-
The Table only gives an indication of the maximum plot ratio which may be allowed for a particular area. However, where there are significant constraints on development capacity (such as transport or infrastructure limitations, or environmental, topographical or geotechnical conditions), or special design considerations, a lower plot ratio may be specified when considered appropriate and possible.
-
In some areas, maximum plot ratios may not be achievable due to Airport Height Restrictions.
(i)
Maximum
domestic plot ratio of 8, 9 and 10 depends on
Site Class A, B and C respectively.
(ii)
If there is non-domestic floorspace, maximum domestic plot ratio will be reduced according to the provisions of the B(P)R composite building formula.
(iii)
The maximum domestic plot ratio is in accordance with those stipulated on OZPs and site class is not relevant.
(iv)
If there is non-domestic floorspace with a plot ratio in excess of 1.5, maximum domestic plot ratio will be reduced by the amount of this excess.
(v)
For this first generation New Town (i.e. Tuen Mun, Sha Tin, Fanling / Sheung Shui, Tai Po, Yuen Long and Tsuen Wan), lease modifications for higher plot ratios than those applicable prior to September 1981 should be permitted only if the proposed development forms the whole or a substantial part of a comprehensive redevelopment plan prepared or approved by the planning authority.
(vi)
Higher maximum domestic plot ratios may be permitted in Comprehensive Development Areas having regard to local circumstances, such as infrastructure capacities. However, for New Development Area and CDA for Tsuen Wan, Kwai Chung & Tsing Yi, the maximum plot ratio is normally 5.
(vii)
Any non-domestic plot ratio component may be in addition to the domestic plot ratio, up to the maximum permitted by the B(P)R composite building formula or those of the OZPs.
(viii)
In existing development areas this maximum domestic plot ratio can only be imposed in the case of lease modifications or Section 16 applications, unless it is incorporated in the OZPs.
(ix)
In Special Control Areas, maximum domestic plot ratio may be further limited.
Important notices